M12 DIN 7980 Hi-Collar Split Lockwasher Alloy Steel Black Oxide

Description

PICTURES ARE REPRESENTATIVE OF ITEM,  BUT ARE NOT OF THE ACTUAL ITEM.
Product dimensions, finish, head markings, thread length, stamping shape or forging shape, etc., may differ from picture. Products are guaranteed to meet the specs to which they are manufactured. Specs allow for tolerances in dimension and shape, which can vary from lot to lot.
Please read the specifications in the table below before buying. If you have any questions, or if your requirements include specific dimensions, please contact us before buying
.
Don't see what you need? Only a small portion of our inventory is listed on eBay. Please call or contact us through eBay messages with your requirements. We respond to email quickly, and in most cases are able to make a listing with the part you need, in the quantity you need, in minutes!
PRODUCT SPECIFICATIONS
Part #:
0000-105748
Fastener Type:
Hi-Collar Split Lockwasher
Size Description:
M12
Diameter/Nominal Size:
M12*
Inside Diameter:
12.2mm-12.7mm
Outside Diameter:
18mm
Thickness:
2.4mm-2.6mm
System of Measurement:
Metric
Property Class:
170 KSI Alloy Steel (Class 12.9)
Material:
Alloy Steel
Finish:
Thermal Black Oxide
Standards Met:
DIN 7980
Average Piece Weight:
0.0050300 lbs.
*Washer Sizing:
Washer sizes are nominal (sized for the bolt that the washer will fit).
Actual inside diameter is almost always larger than stated size.
Please see the Inside Diameter spec in the table above, if available.
Washers are thin disk-shaped plates with a hole that is used to distribute the load of a threaded fastener such as a bolt or nut; often have an outer diameter (OD) about twice their inner diameter (ID), but this can vary based upon the washer. Washers come in many different varieties; flat washers, split lock washers, toothed lock washers, beveled washers in both steel and iron, etc.
For Customer Service
Please Call or Contact Us Through eBay Messaging