REPLACEMENT FOG LIGHT PROJECTOR LAMP FOR CHRYSLER DODGE JEEP 5182021AA 5182021AB

Description

►►I SHIP TO ALASKA, HAWAII & PUERTO RICO
FOR
, READ MORE ABOUT IT BELOW◄◄
ONE
AFTERMARKET REPLACEMENT PROJECTOR GLASS FOG LIGHT/LAMP w/ H11 Halogen Bulb Included
OE PART #
5182021AA, 5182021AB
FITS EITHER SIDE
2014-2015 CHRYSLER 200
2014 CHRYSLER 300
2014-2015 CHRYSLER TOWN AND COUNTRY
2014 DODGE AVENGER
2014-2015 DODGE CHALLENGER
2014 DODGE CHARGER
2014-2015 DODGE DURANGO
2014-2015 JEEP CHEROKEE
THE EASIEST WAY TO CHECK IF THIS LAMP FITS YOUR VEHICLE IS BY CHECKING THE COMPATIBILITY CHART.
(PROFESSIONAL INSTALLATION IS HIGHLY RECOMME
NDED)
Box Contents:
1
Shatter Resistant Projector Style Glass Fog Lamp  w/ H11 12V 55W, clear bulb.
**SCREWS NOT INCLUDED**
**WARRANTY DOES NOT COVER THE BULB**
►
Professional installation is always recommended
SHIPPING INFORMATION
FREE USPS 1ST CLASS
standard shipping is
ONLY
to the 48 continental states U.S.A
ALASKA, HAWAII, PUERTO RICO BUYERS
or
"GET IT QUICKER"
BUYERS
Choose the USPS PRIORITY MAIL shipping option & for your item ships
USPS Priority Mail (3-4 DAYS)
You will always receive a Tracking Number, please track your shipment.
FREE SHIPPING IS ONLY FOR THE ORIGINAL SHIPMENT. ALL PACKAGES DEEMED NON-DELIVERABLE BY THE CARRIER DUE TO AN ADDRESS ISSUE = THE BUYER IS RESPONSIBLE FOR NEW SHIPPING FEES. IF THE BUYER OPTS FOR A REFUND, THE RETURN/REFUND POLICY APPLIES. DETAILS ARE EXPLAINED IN THE "RETURN POLICY" PORTION OF THIS LISTING.
FITMENT ISSUES
Please make sure that this item will fit your vehicle by checking the, “COMPATIBLE VEHICLE”, link in the DESCRIPTION area of this page.
Our products are manufactured to strict OEM specifications; however, there may be slight issues with gaps, especially in lighting. Prior vehicle collision damage, vehicles with prior poor frame alignment have increased chances of an improper fit. Fitment gaps should be no more than 1/3” wide on each side.  Professional installation is HIGHLY recommended.
Vehicle Factory Pre-Installed Wiring Issues
Your vehicle may be equipped with factory pre-installed wiring for fog lights. Most likely, a switch is not included.  If you want to use the existing factory installed wiring, you must go to the dealer and purchase your fog light set from them.  The switch in the set listed here, is not compatible with factory pre-installed wiring.  If you decide to save tons of money and purchase this set, you need to use the harness+switch from this set, by-passing the existing factory wiring.
**CONDENSATION ISSUE**
If fog lights are not installed properly, condensation build-up is possible. Condensation indicates that your light assembly lacks an airtight seal. Climates with extreme weather have an increased chance of condensation build-up.  All light installations are susceptible to condensation if improperly installed. Please make sure all sockets are tightly fastened and all “O” rings or rubber gaskets are in good condition. Dry & cracked “O” rings and/or dry & cracked rubber gaskets on your factory sockets can let moisture in. If you have moisture buildup in your lights, please try the following solution: remove your lights from the vehicle and set out in the sun or in a dry area. Wait until the condensation has fully evaporated, and reseal around the seams with a clear silicone sealant on the assembly and replace any worn “O” rings or rubber gaskets. This should alleviate the condensation issue.